No Ip Domain Lookup; Ip Name-Server - Siemens SCALANCE XM-400 Configuration Manual

Result
The DNS client of the device is enabled and when necessary sends queries to the DNS
server.
7.1.2.7

no ip domain lookup

Description
This command disables the DNS client of the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip domain lookup
Result
The DNS client of the device is disabled.
7.1.2.8

ip name-server

Description
This command specifies an IP address of a DNS server. You can configure up to 3 servers.
If there is more than one server, you can specify the order in which the servers are queried.
To allow this, the optional parameter
queried first.
if you create a server without specifying an index, the server that currently has index 1 will be
overwritten.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
is available. The server with the lowest index is
index
Network protocols
7.1 IPv4 protocol
295