No Route-Map - Siemens SCALANCE XM-400 Configuration Manual

Parameter
deny
seqnum
Result
The route map has been created.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Further notes
You delete a route map with the
You display the setting and other information with the
9.8.2.2

no route-map

Description
With this command, you delete a route map.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
route-map <name(1-20)> [ <seqnum(1-10)> ]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
The routing information is discarded.
Sequence number of the route map
command.
no route-map
show route-map
Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
Range of values / note
-
1 ... 10
If you do not specify a sequence
number, 1 is assigned automatical-
ly.
command.
711