9.5.4.10
no vrrp vrid-track
Description
With this command, you disable VRID tracking.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3)#
Syntax
Call the command without parameter assignment:
no vrrp vrid-track
Result
VRID tracking is disabled.
Further notes
You enable VRID tracking with the
You display configured VRID trackings with the command
interface
9.5.5
Commands in the Interface Configuration mode
This section describes commands that you can call up in the Interface configuration mode.
Note
The commands are only available with layer 3 and only in conjunction with VLAN interfaces.
Router ports are not supported.
In the VRRP3 Router configuration mode, enter the
mode.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
with the parameter
detail
command.
vrrp vrid-track
.
interface
Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
or
show vrrp3
show vrrp3
command to change to this
659