No Protocol-Vlan; Subnet-Vlan - Siemens SCALANCE XM-400 Configuration Manual

Result
The classification is enabled.
Further notes
You disable the setting with the
You can display the status of this function and other information with the
info
6.1.2.6

no protocol-vlan

Description
With this command, you disable the protocol-based classification on all interfaces.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no protocol-vlan
Result
The classification is disabled.
Further notes
You enable the setting with the
You can display the status of this function and other information with the
info
6.1.2.7

subnet-vlan

Description
With this command, you enable IPv4 subnet-based VLAN on all interfaces.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
command.
no protocol-vlan
command.
protocol-vlan
Network structures
6.1 VLAN
show vlan device
show vlan device
195