Ipv6 Dhcp Client Information Refresh Minimum - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.4 DHCPv6 client (IPv6)
Parameter
key-id
value
Result
The HMAC-MD5 function is configured.
Further notes
You configure the interface as a router port with the
You enable the function DHCPv6 client with the
You display the setting with the
7.4.2.2

ipv6 dhcp client information refresh minimum

Description
With this command, you configure the interval after which the DHCP client refreshes the
configuration parameters.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client information refresh minimum <seconds value(600-4294967295)>
The parameter has the following meaning:
Parameters
seconds value
338
Description
Keyword for the ID of the password
ID of the password
show ipv6 dhcp interface
Description
Length of the interval in seconds
Range of values / note
-
Enter a valid ID.
0 ... 4294967295
command.
no switchport
command.
ipv6 address dhcp
command.
Range of values / note
600 ... 4294967295
Default: 4294967295 (24 hours)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11