Ip Igmp Snooping Switch-Ip - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.3 IGMP snooping
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping clear counters [Vlan <vlanid (1-4094)>]
The parameters have the following meaning:
Parameter
Vlan
vlanid
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select a VLAN, the counters of all VLANs will be deleted.
Result
The counters are deleted.
8.3.2.5

ip igmp snooping switch-ip

Description
With this command, you configure the IP address of the source for IGMP snooping.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping switch-ip<switch-ipaddr>
464
Description
Keyword for a VLAN connection
Number of the addressed VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
1 ... 4094
Configuration Manual, 06/2016, C79000-G8976-C252-11