No Rmon Alarm - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.5 RMON
If you do not select a parameter from the parameter list, the events for high and low
threshold values are assigned the lowest event number available in the event table.
Note
MIB variables that can be monitored
With the RMON function, only MIB variables of the Ethernet interfaces can be monitored.
Note
Magnitude of the threshold values
The threshold value for falling or low variable values should be less than the threshold value
for rising or high variable values.
Note
Conditions for working with alarms
The events assigned to the alarms are configured.
The Remote monitoring function is started with the
Result
The alarm for monitoring a MIB variable is configured.
Further notes
You delete an alarm with the
You display the list of configured RMON alarms with the
12.5.2.4

no rmon alarm

Description
With this command, you delete an alarm for monitoring a MIB variable.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
938
rmon
command.
no rmon alarm
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
show rmon alarms