Arp Timeout - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.12 ARP
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no arp <ip address>
The parameter has the following meaning:
Parameter
ip address
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 44)".
Result
The entry is deleted from ARP cache.
Further notes
You generate a static entry in the ARP cache with the
You can display the status of this function and other information with the
command.
You configure the router port with the
7.12.2.3

arp timeout

Description
With this command, you configure the timeout setting of the ARP cache.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
426
Description
Value of the IP address whose entry will be deleted
no switchport
Range of values / note
IP address or IP alias
command.
arp
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ip arp