Diagnostics
12.2 FMP
Further notes
You disable this function with the
You display the status of this function and other information with the
show fmp limit
You define the limit values with the
12.2.2.2
no fmp
Description
With this command, you disable fiber monitoring.
Requirement
You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no fmp
Default: enabled
Result
Fiber monitoring is disabled.
Further notes
You enable this function with the
You display the status of this function and other information with the
show fmp limit
You define the limit values with the
12.2.2.3
fmp power-loss
Description
With this command, you specify the limit values for monitoring the power loss per port.
908
no fmp
commands.
fmp power-loss
command.
fmp
commands.
fmp power-loss
command.
and
fmp rx-power
and
fmp rx-power
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
and
show fmp stauts
commands.
and
show fmp stauts
commands.