Siemens SCALANCE XM-400 Configuration Manual page 404

Network protocols
7.8 SNMP
Parameter
IPAddress
fqdn-name
FQDN
ipv6
IP6-Address
timeout
Seconds
retries
RetryCount
taglist
TagIdentifier
none
volatile
nonvolatile
port
integer
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 42)".
If optional parameters are not specified when configuring, the default values apply.
Result
The SNMP target address is configured.
Further notes
You delete the SNMP target address with the
You display the SNMP target address with the
You configure the SNMP target parameters with the
You display the SNMP target parameters with the
404
Description
IPv4 address
Keyword for a domain name
Domain name (Fully Qualified Do-
main Name)
Keyword for an IPv6 address
IPv6 address
Keyword for the time the SNMP
agent waits for a response before it
repeats the inform request message
Time in seconds
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
Number of attempts
Keyword for tag list
Tag identifier that selects the desti-
nation address for SNMP.
No tag identifier
Specifies whether the settings re-
main following a restart.
Keyword for the port number at
which the SNMP manager receives
traps and inform messages
Port number
no snmp targetaddr
show snmp targetaddr
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Enter a valid IPv4 unicast address.
-
Maximum of 100 characters
-
Enter a valid IPv6 address.
-
1 ... 1500
-
1 ... 3
-
Specify the tag identifier.
-
•
volatile
The default settings are used af-
ter a restart.
•
nonvolatile
The saved settings are used af-
ter a restart.
-
1 ... 65535
command.
command.
snmp targetparams
show snmp targetparam
Configuration Manual, 06/2016, C79000-G8976-C252-11
:
:
command.
command.