8.6 Unicast; The "Show" Commands; Show Unicast-Block Config - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 2 management protocols

8.6 Unicast

The commands in this section configure the procedures for handling Unicast frames.

The commands allow the following:

● Filtering of Unicast frames

● Blocking of ports

● Automatic learning of Unicast

● Blocking unknown Unicast frames.

With the "show" commands, you can display the configuration data.

This section describes commands with which you display various settings.

This command shows the unicast blocking settings for ports.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show unicast-block config [port <interface-type> <interface-id)>]

The parameters have the following meaning:

interface-type

interface-id

For information on names of interfaces and addresses, refer to the section "Interface

identifiers and addresses (Page 42)".

Keyword for a port description

Type or speed of the interface

Module no. and port no. of the interface

Range of values / note

Enter a valid interface

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11