Vrrp Priority - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.5 VRRPv3 (IPv4 / IPv6)

vrrp priority

With this command, you specify the priority of the virtual router. The current master router is

automatically given 255. All other priorities can be distributed freely among the VRRP

routers. The higher the priority, the earlier the VRRP router becomes "Master".

This command is available only with layer 3.

● An IP address is assigned to the virtual router.

● You are in the VRRP3 Interface configuration mode.

The command prompt is as follows:

cli(config-vrrp-v3-if-$$$)#

Call up the command with the following parameters:

vrrp <vrid(1-255)> priority <priority(1-254)>

The parameters have the following meaning:

The priority of the virtual router is specified.

Further notes

You configure a VRRP3 interface with the

You reset the priority to the default with the

You assign IP addresses to a virtual router with the

You display the priority with the

ID of the virtual router

Priority of the virtual router

no vrrp priority

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

vrrp associated-ip

Configuration Manual, 06/2016, C79000-G8976-C252-11