No Snmp Targetaddr; Snmp Targetparams - Siemens SCALANCE XM-400 Configuration Manual

7.8.2.15

no snmp targetaddr

Description
With this command, you delete the SNMP target address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp targetaddr <TargetAddressName>
The parameter has the following meaning:
Parameter
TargetAddressName
Result
The SNMP target address is deleted.
Further notes
You change the SNMP target address with the
You display the SNMP target address with the
7.8.2.16

snmp targetparams

Description
With this command, you configure the SNMP target parameters.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
SNMP target address
show snmp targetaddr
Range of values / note
max. 32 characters
command.
snmp targetaddr
command.
Network protocols
7.8 SNMP
405