No Interface - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.4 VRRPv2 (IPv4)
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
interface vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Further notes
You exit the VRRP Interface configuration mode with the
You delete a VRRP interface with the
You display the status and the configuration of the VRRP interfaces with the
show vrrp interface
9.4.3.2

no interface

Description
With this command, you delete a VRRP interface.
Note
This command is available only with layer 3.
622
Description
Keyword for a VLAN connection
Number of the addressed VLAN
no interface
command.
Range of values / note
-
1 ... 4094
or
end exit
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
or
show vrrp