No Distribute-List - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.3.11

no distribute-list

Description
This command disables the filtering of the routing information according to a route map for
incoming routing information.
Note
This command is available only with layer 3.
Requirement
● OSPFv3 routing is activated.
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(20)> in
The parameters have the following meaning:
Parameter
route-map
name
in
Result
The filtering is disabled.
Further notes
You enable the filtering with the
You enable OSPFv3 routing with the
You display the setting with the
592
Description
Keyword for a route map
Name of the route map
Incoming routing information is fil-
tered.
distribute-list
ipv6 router ospf
show ipv6 ospf
Range of values / note
-
Maximum of 20 characters
-
command.
command.
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11