Radius-Server - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You can display the status of this function and other information with the
information
11.2.2.4

radius-server

Description
With this command, you configure a RADIUS server entry on the RADIUS client.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
radius-server { ipv4 <ipv4-address> | fqdn-name <FQDN> | ipv6 <ipv6-address> } [auth-
port <portno(1-65535)>] [retransmit <1-5>] [key <secret-key-string>] [primary]
[{login | dot1x | login-dot1x}] [test]
The parameters have the following meaning:
Parameter
ipv4
ipv4-address
fqdn-name
FQDN
ipv6
ipv6-address
auth-port
portno
retransmit
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
Description
Keyword for an IPv4 address
IPv4 address of the RADIUS server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
IPv6 address of the RADIUS server
Keyword for the UDP port number for
authentication
Number of the port
Keyword for the number of connection
retries
Enter the maximum number of retries
for an attempted query.
The initial connection attempt is re-
peated the number of times specified
here before another configured
RADIUS server is queried or the login
counts as having failed.
Security and authentication
11.2 RADIUS client
show device
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
-
Enter a valid IPv6 address.
1 ... 65535
Default: 1812
-
1 ... 5
Default: 3 (retries, this means 4
connection attempts)
821