Commands In The Interface Configuration Mode; Ipv6 Dhcp Relay - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameters
enable
disable
Result
The Remote ID is activated.
Further notes
You configure the type of remote ID with the
7.7.4

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
7.7.4.1

ipv6 dhcp relay

Description
With this command, you enable the DHCPv6 relay agent. You can also specify the interface
via which a DHCPv6 server can be reached
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay [destination <prefix> [interface {vlan <vlan-id (1-4094)> |
<interface-type> <interface-id>}]]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Remote ID is used
Remote ID is not used
7.7 DHCPv6 Relay Agent (IPv6)
ipv6 dhcp relay remote-id type
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Network protocols
Range of values / note
-
-
command.
379