Mac-Address-Table Static Unicast - Siemens SCALANCE XM-400 Configuration Manual

8.6.2.1

mac-address-table static unicast

Description
With this command, you generate a static unicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
vlan <vlan-id(1-4094)>
interface ([<interface-type> <interface-id>]
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
interface
interface-type
interface-id
port-channel
interface-list
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry in the forwarding database is generated.
Further notes
With the
configured entries.
With the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
[<interface-type> <0/a-b, 0/c,...>]
[port-channel <interface-list>])
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a port channel connection
Number of the addressed port channel
show mac-address-table static unicast
no mac-address-table static unicast
Layer 2 management protocols
Range of values / note
-
-
1 ... 4094
-
Enter a valid interface.
Enter a valid port channel connec-
tion.
command, you display the list of
command, you delete an entry.
8.6 Unicast
489