Show Interfaces - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
3.1.1.9

show interfaces

Description
This command shows the status and the configuration of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interfaces
[{
|
private-vlan mapping
]
The parameters have the following meaning:
Parameter
interface-type
interface-id
description
stormcontrol
flowcontrol
status
vlan
vlan-id
port-channel
port-channel-id
private-vlan map-
ping
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the status and configuration of
all available interfaces will be displayed.
66
or
cli#
[<interface-type><interface-id>]
[{description|stormcontrol|flowcontrol|status}]
|
{vlan<vlan-id(1-4094)>}
|
port-channel<port-channel-id(1-8)>}
Description
Type or speed of the interface
Module no. and port no. of the interface
Shows the description of the interface
Shows the storm control settings
Shows the flow control settings
Shows the status of the interface.
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
Shows from which secondary PVLANs
the IP interface of the primary PVLAN
is reachable.
Range of values / note
Enter a valid interface.
-
-
-
-
-
1 ... 4094
-
1 ... 8
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11