Security and authentication
11.7 Port-based Network Access Control (Dot1X)
11.7.3.9
dot1x mac-auth port reset
Description
With this command, you reset MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x mac-auth port [mac <aa:aa:aa:aa:aa:aa>] reset
The parameters have the following meaning:
Parameter
mac
aa:aa:aa:aa:aa:aa
Result
MAC authentication is reset for the port.
11.7.3.10
dot1x mac-auth vlan-assign
Description
With this command you enable the assignment of the VLAN ID for a MAC address by the
RADIUS server.
The port can only be assigned to the VLAN, if the VLAN has been created on the device.
Otherwise Authentication is rejected.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
876
Description
Keyword for a MAC address
MAC address of the interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
aa:aa:aa:aa:aa:aa
Configuration Manual, 06/2016, C79000-G8976-C252-11