Commands In The Route Maps Configuration Mode; Match Destination Ip - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

The parameters have the following meaning:

The route map has been deleted.

Further notes

You create a route map and change to the Route maps configuration mode with the

You display the setting and other information with the

Commands in the Route maps configuration mode

This section describes commands that you can call up in the Route maps configuration

In the global configuration mode, enter the

● If you exit the Route maps configuration mode with the

global configuration mode.

● If you exit the Route maps Configuration mode with the

Privileged EXEC mode.

With this command, you specify whether or not the routing information for a route map is

filtered based on the destination IPv4 address.

This command is available only with layer 3 (IPv4).

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Name of the route map

Sequence number of the route map

Range of values / note

show route-map

command to change to this mode.

command, you return to the

command, you return to the

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11