Layer 2 management protocols
8.3 IGMP snooping
8.3.2.1
ip igmp snooping version
Description
This command specifies which version of IGMP snooping the device will use. When shipped,
the device uses IGMPv3.
Note
There is no separate show command to display the version of IGMP used by the device.
This information is shown when you enter the
EXEC mode or in the Privileged EXEC mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping version {v1 | v2 | v3}
The parameters have the following meaning:
Parameter
v1
v2
v3
Result
The version of IGMP snooping used by the device is specified.
8.3.2.2
ip igmp vlan-snooping
Description
With this command, you enable IGMP snooping for all VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
462
show ip igmp snooping
Description
IGMPv1
IGMPv2
IGMPv3
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command in the User
Configuration Manual, 06/2016, C79000-G8976-C252-11