Commands In The Interface Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip access-list standard<access-list-number(1-128)>
The parameters have the following meaning:
Parameter
standard
access-list-number
Result
The access control list is deleted.
Further notes
You generate an IP access control list with the
You display the configuration of the access control list with the
11.4.3

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
836
Description
Specifies that a standard access con-
trol list is generated
Number of the standard access control
list
interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
1 ... 128
command.
ip access-list
show access-lists
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.