No Interface - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
Result
You are now in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Further notes
You exit the VRRP3 Interface configuration mode with the
You delete a VRRP3 interface with the
You display the status and the configuration of the VRRP3 interfaces with the
show vrrp3 interface
9.5.4.2

no interface

Description
With this command, you delete a VRRP3 interface.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Syntax
Call up the command with the following parameters:
no interface vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
652
no interface
command.
Description
Keyword for a VLAN connection
Number of the addressed VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
or command.
end exit
command.
Range of values / note
-
1 ... 4094
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
show vrrp3