Siemens SCALANCE XM-400 Configuration Manual page 624

Layer 3 functions
9.4 VRRPv2 (IPv4)
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
track <group-index> interface { vlan <vlan-id (1-4094)> | <interface-type>
<interface-id> }
The parameters have the following meaning:
Parameter
group-index
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The selected interface is monitored.
Further notes
You delete an interface tracking with the
You display the configured interface tracking with the
You assign a VRRP interface to an interface tracking with the
command.
You configure the value by which the priority is reduced with the command
decrement
With the
change their status before the priority of the assigned VRRP interface is changed.
624
Description
ID of the interface tracking
Keyword for a VLAN connection
Number of the addressed VLAN
Type of interface
Module no. and port no. of the interface
.
command you configure how many of the monitored interfaces need to
track links
Range of values / note
-
-
1 ... 4094
Specify a valid interface.
no interface interface
show vrrp track
vrrp track decrement
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
vrrp track