Siemens SCALANCE XM-400 Configuration Manual page 904

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

12.1 Event and fault handling

The parameters have the following meaning:

interface-id

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

If you do not select an interface, the function is disabled for all available interfaces.

The settings for monitoring the physical network connections have been configured.

Further notes

You can display the current setting with the

You enable the function with the

The message when establishing a connection is

The message when a connection is down is disa-

Type or speed of the interface

Module no. and port no. of the interface

Range of values / note

Enter a valid interface.

show events faults config

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11