No Version - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.6 RIPv2 (IPv4)

You are in the RIPv2 Router configuration mode.

The command prompt is as follows:

cli(config-rip)#

Call up the command with the following parameters:

version <1 | 2| 12 | none>

The parameters have the following meaning:

It has been specified which RIP packets will be processed.

no version

The updating of route information is according to RIPv1 or RIPv2 (default for this parameter)

You are in the RIPv2 Router configuration mode.

The command prompt is as follows:

cli(config-rip)#

Call the command without parameter assignment:

Only routing information corresponding

to RIPv1 (RFC 1058) is evaluated and

Only routing information corresponding

to RIPv2 (RFC 2453) is evaluated and

Only routing information corresponding

to RIPv1 and RIPv2 is evaluated and

There is no processing of routing in-

formation using RIP.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

Routing information is only dis-

tributed and received using

Routing information is only dis-

tributed and received using mul-

ticasts (224.0.0.9).

Routing information is distributed

and received using broadcasts

and multicasts (224.0.0.9).

Default setting

Configuration Manual, 06/2016, C79000-G8976-C252-11