Area - Siemens SCALANCE XM-400 Configuration Manual

9.3.3.1

area

Description
With this command, you configure areas of the type NSSA (not-so-stubby-area) or stub.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
area <area-id>
{ {
stub | nssa
} [
no-summary
] }
The parameters have the following meaning:
Parameter
area-id
stub
nssa
no-summary
Result
The area of the type NSSA or stub is configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Area ID
Stub area
The LSA types router, network, inter-
area prefix, intra-area prefix and link
are stored in the database.
NSSA
Stub area that also has external rout-
ing information (NSSA-LSA)
NSSA / stub areas doe not receive
any inter-area prefix LSAs (summary
LSA)
Layer 3 functions
9.3 OSPFv3 (IPv6)
Range of values / note
Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
-
-
only with area border routers
579