Siemens SCALANCE XM-400 Configuration Manual page 36

Description
2.2 Structure of the Command Line Interface
User EXEC mode
This mode is active after you log in with the role "
you can use
not possible to modify parameters in this mode.
To be able to modify configuration parameters, you need to change to the Privileged EXEC
mode.
Privileged EXEC mode
You change to this mode if you log in with the role "admin" or in User EXEC mode you enter
the command
1. The
2. The
User EXEC mode. (The
Global configuration mode
In this mode, you can make basic configuration settings. In addition to this, you can also call
up modes for the configuration of special interfaces or functions, for example to configure a
VLAN or a C-PLUG. You change to this mode by entering
Privileged EXEC mode. To exit this mode, enter
Other configuration modes
From the Global configuration mode, you can change to other configuration modes for
special tasks. These are either general configuration modes (for example line configuration,
interface configuration) or protocol-specific configuration modes (SNTP, NTP).
36
commands to display the current values of configuration parameters. It is
show
. There are two ways of exiting the Privileged EXEC mode:
enable
command logs you out; the Login Prompt prompt appears.
exit
command brings you back one level from the Privileged EXEC mode to the
disable
disable
" in a console window. In this mode,
user
command is not available in the User EXEC mode.)
configure terminal
.
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
in the