9.4.3.4
no track interface
Description
With this command, you delete the tracking of interfaces.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
no track <group-index> interface { vlan <vlan-id (1-4094)> | <interface-type>
<interface-id> }
The parameters have the following meaning:
Parameter
group-index
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
Interface tracking is deleted.
Further notes
You configure an interface tracking with the
You display the configured interface tracking with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
ID of the interface tracking
Keyword for a VLAN connection
Number of the addressed VLAN
Type of interface
Module no. and port no. of the interface
track interface
Layer 3 functions
9.4 VRRPv2 (IPv4)
Range of values / note
-
-
1 ... 4094
Specify a valid interface.
command.
command.
show vrrp track
625