No Ip Nat Service Portrange - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.9 NAT (IPv4)
9.9.3.10

no ip nat service portrange

Description
With this command you delete static port translations (NAPT) for an interface with a port
range.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat service portrange <inside local ip> {tcp|udp|any} <inside local start port
no> <inside local end port no>
The parameters have the following meaning:
Parameter
inside local ip
Protocol
inside local start
port no
inside local end
port no
Result
The static port translation with a port range is deleted.
Further notes
You configure static port translations for an interface with a port range with the
service portrange
You configure static port translations with a service for an interface with the
command.
You display the current configuration with the
750
Description
Actual address of the device that is
reachable from external.
Protocol for which the port translation
is valid.
Start port that is assigned to the inside
local address.
End port that is assigned to the inside
local address.
command.
Range of values / note
Enter a valid IPv4 address.
•
tcp
•
udp
•
any
-
-
show ip nat service portrange
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ip nat
ip nat service
command.