Track Interface - Siemens SCALANCE XM-400 Configuration Manual

Result
The VRRP3 interface has been deleted.
Further notes
You configure a VRRP3 interface with the
You display the status and the configuration of the VRRP3 interface with the
show vrrp3 interface
9.5.4.3

track interface

Description
With this command, you configure the tracking of interfaces.
When the link of one or more tracked interfaces changes from "up" to "down", the priority of
the assigned VRRP interface is reduced. When the link of the interface changes back from
"down" to "up", the original priority of the VRRP interface is restored.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3)#
Syntax
Call up the command with the following parameters:
track <group-index> interface { vlan <vlan-id (1-4094)> | <interface-type>
<interface-id> }
The parameters have the following meaning:
Parameter
group-index
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
interface
command.
Description
ID of the interface tracking
Keyword for a VLAN connection
Number of the addressed VLAN
Type of interface
Module no. and port no. of the interface
9.5 VRRPv3 (IPv4 / IPv6)
command.
Range of values / note
-
-
1 ... 4094
Specify a valid interface.
Layer 3 functions
or
show vrrp3
653