Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ptp info [ interfaces <interface-type> <interface-id> ]
The parameters have the following meaning:
Parameter
interfaces
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The current settings for the Precision Time Protocol (PTP) are displayed.
5.4.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
5.4.2.1
ptp
Description
With this command, you enable the Precision Time Protocol for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Keyword for a an interface name.
Type or speed of the interface.
Slot no. and port no. of the interface.
command to change to this mode.
configure terminal
or
end
exit
System time
5.4 PTP Client
Range of values / note
-
Enter a valid interface name.
command and are then in the
173