Show Lacp - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

If you do not select an interface, information for all interfaces is displayed.

The interface-specific information for a port channel is displayed.

When a port is assigned to a link aggregation but is not active (e.g. link down), the values

displayed may differ from the values configured for the link aggregation.

If the port in the link aggregation becomes active, individual port configurations such as DCP

forwarding are overwritten with the configured values of the link aggregation.

show lacp

This command shows the information about the settings and information about the ports

involved in the link aggregation. The number of sent and received packets is also displayed.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show lacp [<port-channel(1-8)>]{counters|neighbor[detail]}

The parameters have the following meaning:

port-channel

If you do not select a port channel, information for all available interfaces is displayed.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Number of the Channel-Group

Shows the values of the counters

Displays information on neighbor ports

Displays detailed information on neigh-

Network structures

6.2 Link aggregation

Range of values / note