Port Access Control List Locked Ports; The "Show" Commands; Show Lock Port - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Port Access Control List Locked Ports

With the Port Access Control List Locked Ports functionality, MAC addresses that do not age

are collected on a port after the

are converted to static entries in the address list and the aging is reactivated for all the

addresses that follow.

If the learning of addresses on this port is then disabled, data packets are only forwarded to

the static addresses entered in the table.

This section describes commands relevant for the configuration of this function.

This section describes commands with which you display various settings.

This command shows whether or not the learning of MAC entries is enabled or locked on an

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show lock port [<interface-type><interface-id>]

The parameters have the following meaning:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

If you do not select an interface, the configuration of all interfaces is displayed.

The configuration of the interface for the learning of MAC entries is displayed.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Type or speed of the interface

Module no. and port no. of the interface

11.5 Port Access Control List Locked Ports

command. With the

Security and authentication

command, these addresses

Range of values / note

Enter a valid interface.