Save Filetype - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Configuration

3.2 Load and Save

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

For information on the file types , refer to this list (Page 109).

The file is loaded on the device from the TFTP server.

save filetype

With this command, you save files on a TFTP server.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

save filetype <filetype> tftp {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6

<ip6_addr>} [port <tcpport (1-65535)>] file <filename>

Keyword for a domain name

Domain name (Fully Qualified Domain

Name) of the TFTP server

Keyword for an IPv6 address

IPv6 address of the TFTP server

Keyword for the port of the server via

which the TFTP connection runs

Number of the port

Keyword for a file name to be assigned -

Name of the file

Keyword for the file type to be loaded

Name of the file type

Range of values / note

Maximum of 100 characters

Enter a valid unicast IPv6 ad-

Maximum of 100 characters

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11