No Relay-Information - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
Further notes
You cancel the assignment with the
You display the setting with the
You enable the IPv4 address band with the
7.5.3.11

no relay-information

Description
With this command you cancel the assignment of devices with a certain remote ID and circuit
ID to IPv4 addresses from a specific address band.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no relay-information <remote-id> <circuit-id>
The parameters have the following meaning:
Parameter
remote-id
circuit-id
Result
The assignment is canceled.
Further notes
With the
circuit IPv4 addresses from a specific address band.
You display the setting with the
You enable the IPv4 address band with the
362
Description
Remote ID of the device
Circuit ID of the device.
command, you assign devices with a certain remote ID and
relay-information
no relay-information
show ip dhcp relay information
pool-enable
show ip dhcp relay information
pool-enable
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
command.
Range of values / note
Enter the remote ID of the de-
vice.
Enter the circuit ID of the de-
vice.
command.
command.