No Switchport Pvid - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Result
The PVID is configured
Further notes
You can reset the setting to the default with the
You configure the VLAN ID with the
You display the setting and other information with the
6.1.3.21

no switchport pvid

Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
Result
The setting is reset to the default value.
Further notes
You configure the setting with the
You configure the VLAN ID with the
You can display the status of this function and other information with the
config
216
command.
no switchport pvid
switchport access vlan
show vlan port config
command.
switchport pvid
switchport access vlan
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
command.
command.
show vlan port