Layer 3 functions
9.4 VRRPv2 (IPv4)
9.4.2.1
router vrrp
Description
With this command, you enable routing with VRRP and change to the VRRP Router
Configuration mode.
Note
This command is available only with layer 3.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router vrrp
Result
Routing with VRRP is enabled.
You are now in the VRRP Router Configuration mode.
The command prompt is as follows:
cli (config-vrrp)#
Further notes
You disable routing with VRRP with the
9.4.2.2
no router vrrp
Description
With this command, you disable routing with VRRP.
Note
This command is available only with layer 3.
620
command.
no router vrrp
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11