Show Ip Ospf Border-Routers - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
area-id
asbr-summary
external
network
nssa-external
router
summary
link-state-id
adv-router
ip-address
self-originate
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The information on the selected LSA type is displayed.
9.2.1.5

show ip ospf border-routers

Description
This command shows the routes to the area border routers and to the AS boundary routers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Area-ID
only shows information of the LSA type
ASPR (Autonomous System Border
Router). (Type 4)
only shows information of the LSA type
"External" (Type 5)
only shows information of the LSA type
"Network" (Type 2)
only shows information of the LSA type
"NSSA (Not so stubby area) External"
(Type 7)
only shows information of the LSA type
"Router" (Type 1)
only shows information of the LSA type
"Summary" (Type 3)
ID of the LSA .
Link State ID depends on the LSA
type.
Keyword for the router-specific LSA
shows the router-specific LSA for a
specific IP address
Number of LSAs generated by the local
router
or
cli#
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area.
-
-
-
-
-
-
Link State ID consists of 4 num-
bers each between 0 and 255
-
specify a valid IP address.
If no IP address is entered, the
specific LSAs of the local router
are displayed.
-
515