Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show traceroute {ip | ipv6 }
The parameters have the following meaning:
Parameter
ip
ipv6
Result
The route is displayed.
Further notes
You enable the following of the route with the
3.1.1.16
show unicast-block config
Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show unicast-block config [port <interface-type> <interface-id)>]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
The destination is an IPv4 address
The destination is an IPv6 address
or
cli#
Range of values / note
-
-
command.
traceroute
Configuration
3.1 System
71