No Ip Igmp Robustness - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call up the command with the following parameters:

ip igmp robustness <value(1-3)>

The parameter has the following meaning:

The setting for the packet loss rate of a network is specified.

Further notes

You can reset the setting to the default with the

You display the setting and other information with the

no ip igmp robustness

With this command, you reset the setting for the packet loss rate of a network to the default

You are in the Interface Configuration mode of VLAN.

The command prompt is as follows:

cli(config-if-vlan-$$$)#

Call the command without parameter assignment:

ip igmp robustness

The setting for the packet loss rate of a network is reset.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Value for the time interval

Layer 2 management protocols

Range of values / note

Select the setting 1 for networks with a low

packet loss rate.

Select the setting 3 for networks with a

higher packet loss rate.

no ip igmp robustness

show ip igmp global-config