Layer 3 functions
9.3 OSPFv3 (IPv6)
Further notes
You change the type of the area with the
You can display the status of this function and other information with the
areas
You display the content of the database with the
command.
9.3.3.2
no area
Description
With this command, you remove or change an area. To remove an area, there must be no
IPv6 interface connected to it.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[ {
{range {summary | Type7} | summary-prefix}
<IPv6-Prefix> <Prefix-Length>
} ]
The parameters have the following meaning:
Parameter
Description
area-id
Area ID
stub
Stub area
nssa
NSSA
580
command.
stub | nssa | virtual-link <router-id> |default-metric |
command.
no area
show ipv6 ospf ... database ...
Range of values / note
Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area and cannot be
deleted.
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 ospf