Commands In The Interface Configuration Mode; Switchport Ingress-Filter - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.2 Static MAC filtering
Syntax
Call up the command with the following parameters:
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry is deleted from the forwarding database.
Further notes
With the
configured entries.
With the
10.2.2

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
10.2.2.1

switchport ingress-filter

Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
786
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
show mac-address-table static unicast
mac-address-table static unicast
Range of values / note
-
-
1 ... 4094
command, you display the list of
command, you create an entry.
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11