No Ip Address - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Network protocols

7.1 IPv4 protocol

no ip address

With this command, you delete the assignment of an IPv4 address to an interface and

disable DHCP.

You are in the Interface configuration mode of VLAN or a router port.

The command prompt is as follows:

cli(config-if-vlan-$$$)#

or with a router port:

cli(config-RPort-if-Int$-$)

Call up the command without parameters or with the following parameter assignment:

no ip address [<ip-address> | dhcp]

The parameter has the following meaning:

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

If DHCP was enabled on this interface, DHCP is now disabled. Any existing dynamically

learned IPv4 address will be automatically converted to a static IPv4 address.

If static IPv4 addresses were configured and if no explicit IPv4 address was transferred as a

parameter, all static IPv4 addresses will be deleted from this interface.

If a static IPv4 address was specified explicitly, this address is deleted from this interface.

Effectiveness of the command

The command is effective immediately.

If you configure the interface via which you access the device, you can lose the connection!

IPv4 address of the interface that will

Specify this parameter if you want to

disable the DHCP function explicitly.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

Enter a valid IPv4 address

Configuration Manual, 06/2016, C79000-G8976-C252-11