No Ip Dhcp Server - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
Requirement
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp server <ip address>
The parameter has the following meaning:
Parameter
ip address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP address is specified.
Further notes
You remove the IP address with the
You enable the DHCP Relay Agent with the
You display the IP addresses with the
You display the settings with the
7.6.2.2

no ip dhcp server

Description
With this command, you delete the IP address of the DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
368
Description
IPv4 address of the DHCP server
no ip dhcp server
service dhcp-relay
show dhcp server
show ip dhcp relay information
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
enter a valid IP address
command.
command.
command.
command.
Configuration Manual, 06/2016, C79000-G8976-C252-11