Layer 3 functions
9.2 OSPFv2 (IPv4)
Result
The address range is created.
Further notes
You delete the address range with the
You can display the status of this function and other information with the
area-range / summary-address
9.2.3.27
no summary-address
Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no summary-address <Network> <Mask> <AreaId>
The parameters have the following meaning:
Parameter
Network
Mask
AreaId
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
550
no summary-address
command
Description
IP address of the address range
Subnet mask of the address range
Area-ID
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
Range of values / note
specify the IP address
specify the subnet mask.
specify a valid ID.
x.x.x.x
x = 255
0.0.0.0 = backbone area
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ip ospf -