9.9.1.3
show ip nat service portrange
Description
This command shows static port translations (NAPT) for an interface with a port range.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip nat service portrange
Result
The selected service, start and end port of an interface are displayed.
Further notes
You configure static port translations for an interface with a port range with the
service portrange
You delete a configuration with the
9.9.1.4
show ip nat summary
Description
This command shows the NAT/NAPT configuration of the interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip nat summary
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
command.
or
cli#
no ip nat service portrange
Layer 3 functions
9.9 NAT (IPv4)
ip nat
command.
737