Show Spanning-Tree Interface Layer2-Gateway-Port - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
Parameter
stats
detail
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The settings of the ports for the spanning tree function are displayed.
6.3.1.6

show spanning-tree interface layer2-gateway-port

Description
This command shows the settings of Layer 2 Gateway Port (L2GP). For example the priority,
the MAC address and the status of L2GP are displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show spanning-tree interface
[<interface-type><interface-id>]
layer2-gateway-port
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The settings for Layer 2 Gateway Port (L2GP) are displayed.
238
Description
Shows the counters of the various
BPDU transmissions.
Shows detailed information about the
spanning tree settings of the interface.
or
cli#
Description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
-
Range of values / note
Enter a valid interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11