Further notes
You disable the option with the
You enable the DHCP Relay Agent with the
You configure the content of the information with the
command.
You can display the status of this option and other information with the
information
7.6.2.5
no ip dhcp relay information option
Description
With this command, you disable the "IP DHCP Relay Information" option.
Requirement
You are in the Global configuration mode or in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay information option
Result
The option is disabled.
Further notes
You enable the option with the
You can display the status of this option and other information with the
information
7.6.2.6
service dhcp-relay
Description
With this command, you enable the DHCP relay agent on the device. The DHCP relay agent
forwards DHCP queries to DHCP servers located in a different subnet.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
no ip dhcp relay information option
command.
or
cli(config-if-$$)#
ip dhcp relay information option
command.
7.6 DHCPv4 Relay Agent (IPv4)
command.
service dhcp-relay
ip dhcp relay circuit-id option
command.
Network protocols
command.
show ip dhcp relay
show ip dhcp relay
371